12/3/2022 0 Comments Mt mograph motion 2 wont install![]() The cambox on a DT/DM is unable to rotate by hand Refer to : Side Mount (SMTC) - VF/VM/UMC/EC - Carousel and Pocket - Troubleshooting Guide The pocket spring or plungers are worn or damaged. The double arm cannot correctly engage with the tool. Tools fall out of the arm during rotation. ![]() Straighten and smooth the double arm or replace it. Replace the worn parts in the double arm.įind the cause of the double arm bending. The toolholders or pull studs are incorrect.Ĭheck for correct tool weight specifications. Tools fall out of the spindle side during a tool change. Inspect and replace the quick exhaust if needed. If the quick exhaust is not working properly it may cause the tool to drop slightly or be miss positioned during the tool change. The TRP quick exhaust is not functioning properly Refer to VMC - Servo-Driven Side-Mount Tool Changer - Grid Offset and Tool Changer Offset. Set the correct values for the Parameters 481 and 487. The values of Parameters 481 or 487 are incorrect in a machine with a servo-driven side-mount tool changer. Move the obstructions or set a safe tool change position.įind the cause of the spindle orientation error. The cambox drive belt is worn or damaged.Īlarm 628/673 ATC/TA ARM POSITIONING ERROR Pressing after updating software generates a 2066 alarm Rotate the arm in recovery mode and test the sensors. One or more of the proximity sensors or cables on the cambox have a bad connection or is damaged. ![]() VMC, HMC - Side-Mount Tool Changer - Manual Recovery Video - Tool Changer Recovery - Side Mount Tool Changer (SMTC) The tool changer arm is not at the origin position when the machine is powered on, or it was not recovered correctly. Alarm 2066 TOOL CHANGER HOME POSITION FAULT ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |